Velleman DVR8L1 Guide D'installation Rapide page 5

= SLOW + ZOOM
Press SLOW and ZOOM simultaneous to enter/exit PTZ control mode. In PTZ mode
PTZ
press
buttons.
= SEQ +
AUDIO
Press SEQ and
= MENU + ENTER
KEY LOCK Press MENU and ENTER simultaneously to lock the front panel keys. Press any key
followed by the DVR password to unlock the keys.
rear panel
1 ~ 8/16 8 (or 16) video input channels to connect up to 8 (or 16) external video sources
e.g. cameras.
MONITOR 1 video output channel to connect the DVR to the main monitor.
AUDIO IN 4 audio inputs to connect external audio sources e.g. from cameras with audio.
Audio IN 1, 2, 3 and 4 are linked with channel 1, 2, 3 and 4 respectively.
AUDIO OUT 1 audio output to connect to an audio device, e.g. a speaker.
VGA to connect a VGA monitor
IR connect the IR receiver for the remote control
LAN port Connect the DVR to a local network by plugging a network cable into this port.
LINK ACT. LED is on when a connection with the network is established
To quickly backup or upgrade firmware/OSD, connect a compatible USB flash
drive to this USB port.
USB port
Note: prior to using the USB flash drive, make sure it is formatted in "FAT32"
format.
EXTERNAL I/O use this port to connect external devices e.g. external alarms, PTZ cameras, ...
19V DC Power supply input.
6. Hardware setup
Installing the Hard Disk Drive (HDD)
Refer to the illustrations on page 2 of this manual.
• Obtain a suitable HDD (not included), type SATA (Serial Advanced Technology Attachment).
• Make sure to unplug the device from the mains before servicing and do not touch any electronic
circuitry to avoid electrostatic discharge.
• Unscrew the 5 screws (1 on either side and 3 on the back) that hold the cover in place.
• Lift the cover (back-end first).
• Screw the mounting brackets on the HDD(s) (screws included).
Note: the PCB must be facing upwards when mounting the HDD into the DVR.
• Connect the master SATA data cable (left connector, see PCB) and power supply to the first HDD;
connect the slave SATA data cable (right connector, see PCB) and power supply to the second HDD
when applicable.
• Screw the HDD(s) on the bottom of the DVR housing PCB facing upwards using the included
screws.
• Close the cover (front first) and secure it with the 5 screws.
Connecting a video monitor
• Obtain a suitable monitor (not included) and connect it to the video out port on the back of the
DVR. Connector type is BNC.
Connecting the power supply
• Plug the DC output connector of the included power adaptor into the 19VDC power input at the
back of the DVR.
WARNING: only use the included adaptor.
• Plug the included power cable into the adaptor input connector and plug the other end into the
mains. Do not switch the DVR on yet.
Connecting a camera
• Obtain up to 8 (or 16) suitable cameras (not included). Each camera needs its own power supply.
• Connect the video output of the camera to either video input at the back of the DVR. The number
next to the input connectors represents the channel number. Connector type is BNC.
22/07/2009
DVR8L1 - DVR16L1
to zoom in, to zoom out. To adjust PTZ angle, press the direction
simultaneous to select the desired audio channel.
5
Rev. 01
© 2009 Velleman Components nv