Live Mode; Aligning The Camera - Velleman CAMCOLVC26N Mode D'emploi

CAMCOLVC26N

7.5 Live Mode

In live mode, photos are triggered by
movement sensors or at intervals
according to the respective setting.
To set up the live mode, switch to the
ON position. The red status LED flashes
for 5 seconds, after which the camera
operates automatically and enters the
standby mode. Recording photos or
videos starts as soon as an animal
enters the detection area of the PIR
sensor zone.

7.6 Aligning the Camera

The test mode is advantageous for determining the best possible detection
angle and range of the movement sensor. For this purpose, attach the
camera to a tree at a height of approximately 1-2 m, and align the camera
with a desired direction.
Move slowly from one side of the observed area to the other. Move parallel
to the camera and try out different angles and distances.
The red LED [L] indicates that you were detected by the PIR sensor zone.
In order to prevent incorrect signals and unnecessary photos, we
recommend not using the camera at sunny points and check that no
branches are in the active area of the sensor. Optimum alignment is in
North or South direction. The detection range of the sensor is approximately
60°.
Also, check that the camera is installed at the correct height in line with the
point to be observed. When necessary, point the camera down for optimum
alignment.
Note
This camera corresponds to protection class IP54. It is protected against
dust and spray, and can thus be used in any weather condition.
V. 01 – 20/09/2016 13 ©Velleman nv