Fm Radio; Bluetooth Audio - Loewe klang s1 Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
Loewe klang s1/s3
Digital radio DAB+ | FM Radio | Bluetooth Audio
12.1 Station search
To search for receivable stations, you can start
an automatic search. To do this, use the
button to open the menu and select [Scan].
The [Scan] appears on the display, as well as
the number of stations found so far and a cor-
responding progress bar. The stations are then
saved in alphabetical order.
Stations that were found during a previous
search but cannot currently be received are
shown in the station list with a "?" in front of the
station name.
12.2 Manual tune
You can also set ensembles manually. To do this,
use the
button to call up the menu and select
[Manual tune]. Then select the desired station
and confirm with OK. Now information about the
ensemble and the signal strength are displayed.
Another pressing of the OK button saves the
corresponding stations in the list.
12.3 Station list
Press the
button and confirm [Station list]
with OK. Use the
/
buttons to select a
station and press OK to confirm. The device
starts playing automatically.
Note: The reception quality of a station depends
on factors such as weather, installation location
and antenna orientation. If a station from the
station list cannot be received, change the
orientation of the antenna or the location of the
radio. Stations that can no longer be received
can be removed from the station list.
12.4 Delete stations that can no
longer be received
Stations that can no longer be received can be
deleted from the list. To do this, press the
button and select [Prune invalid]. Under [This
removes all invalid stations, continue?]
select [YES] and these stations will be deleted.
Selecting [NO] takes you back into the menu
without deleting the stations.
12.5 Favourites (memory
locations)
40 memory locations (favourites) are available
for storing DAB+ stations.
12.5.1 Storing DAB+ stations on the
direct selection buttons Fav1
or Fav2 on the radio
(klang s1 only):
On the radio, you can assign memory locations
1 - 2 using the keys on the unit. To do this, select
the desired station and press a Fav1 or Fav2 key
until [Preset stored] appears on the display.
The memory locations can be called up by
pressing the button briefly.
12.5.2 Saving DAB+ stations in
memory locations 1 - 40
Select the desired station and hold down the
button on the radio or on the remote control.
Now select a memory location from the list of
station memories and confirm the selection with
the OK button on the radio or on the remote
control. The [Preset stored] appears on the
display.
You can easily call up the memory locations by
briefly pressing the
button on the radio or on
the remote control. Use the
/
select a station and press OK to confirm.
Note: The memory locations cannot be deleted,
but can only be overwritten with other stations.
12.6 DRC (Dynamic Range
Control)
Some DAB+ stations support DRC, which redu-
ces the difference between loud and soft tones.
The following settings are possible:
[DRC high]:
Strong compression of the different volumes.
The dynamic is greatly reduced.
[DRC low]:
Low compression without much loss of dyna-
mics.
[DRC off]:
There is no compression.
To make the settings, proceed as follows:
Press the
button and select [DRC]. The
settings for DRC can be changed in the following
menu. The current setting is indicated by [*].
12.7 Station order
By default, the radio sorts the stations in alpha-
betical order. The stations can also be sorted
by ensembles. To make the settings, proceed
as follows:
button and [Station order]. The
Press the
settings can be changed in the following menu.
The current setting is indicated by [*].
13

FM Radio

Before you can tune and listen to FM radio,
you will need to install antenna (not provided
within the scope of delivery) on the back side
of the radio.
Select [FM RADIO] in the home menu to switch
to FM reception.
13.1 Station search
You can automatically search for FM stations. To
start the automatic station search, please press
the OK button on the remote control or on the
radio. The search stops at the next station found
and starts playing.
13.2 Search settings
You can use this function to determine whether
only stations with a strong reception signal
are taken into account. To do this, press the
, button and select [Scan setting]. In the
following menu [FM station scan] you can
now answer the question [Strong stations
only] with [YES] or [NO]. The current setting
is identified by [*].
13.3 Audio settings
buttons to
For stations with poor reception, a slight quality
improvement can be achieved by switching to
mono reception. To do this, press the
and select [Audio setting]. In the following
menu [FM weak reception] you can now
answer the question [Listen in Mono only]
with [YES] or [NO]. The current setting is
identified by [*].
13.4 Favourites (memory
locations)
40 memory locations (favourites) are available
for storing FM stations.
13.4.1 Storing FM stations on the
direct selection buttons Fav1
or Fav2 on the radio
(klang s1 only):
On the radio, you can assign memory locations
1 - 2 using the keys on the unit. To do this, select
the desired station and press a Fav1 or Fav2 key
until [Preset stored] appears on the display.
The memory locations can be called up by
pressing the button briefly.
13.4.2 Storing of FM stations in
memory locations 1 - 40:
Select the desired station and hold down the
button on the radio or on the remote control.
Now select a memory location from the list of
station memories and confirm the selection with
the OK button on the radio or on the remote
control. The [Preset stored] appears on the
display.
You can easily call up the memory locations by
briefly pressing the
the remote control. Use the
select a station and press OK to confirm.
Note: The memory locations cannot be deleted,
but can only be overwritten with other stations.
14

Bluetooth Audio

The Bluetooth function enables the wireless
transmission of music files (audio streaming)
to the radio. Smartphones, tablets or similar
devices can be paired. To do this, select the
source [Bluetooth Audio] in the home menu.
button
button on the radio or on
/
buttons to
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Klang s3

Table des Matières