Preparation; Trimming­hair - Grundig MC 3320 Mode D'emploi

OPERATION

Preparation

1
Remove all packaging and keep
safe for future storage.
2
Inspect the appliance before use
to ensure the blades are free of
hair, debris etc.
3
Check if the mains voltage of
­
the type plate of the appliance
corresponds to your local mains
supply.
4 Plug the power cord into the
wall socket.
Trimming­hair
1
Put on a comb
grade you need (see Controls
and parts).
2
To do this, put the teeth of the cut-
ting head in the central groove of
the comb and gently press on the
bottom blade
until it catches.
B
3
Place a towel around the neck
and shoulder of the person whose
hair you are trimming. Make sure
the person is seated so that their
head is roughly at your eye level.
This allows ease of visibility while
cutting and a relaxed hold on the
appliance.
­____________________
for the cutting
F
of the top blade
A
4
Switch on the appliance using
the switch
D
5
Turn off the appliance using the
switch D when you have fin-
ished trimming.
6 Take off the comb. Gently pull
the bottom catch away from the
cutting head until it comes loose.
Then lift off the comb.
Using­the­blade­lever
Notes
The lever adds versatility to
7
your clipper by allowing you to
gradually change the closeness
of your cut without an attachment
comb.
When the lever is in the uppermost
7
position, the blades will give
you the closest cut and leave the
hair very short. Pushing the lever
downward gradually increase the
cutting length.
In its lowest position, the lever
7
will leave the hair approximately
the same length as comb #1.
The lever will also extend the use
7
of your blades since the different
cutting edge is used in each
setting.
and start trimming.
­
ENGLISH 21­