Pump Assembly - Bartscher 100.321 Mode D'emploi

Pump Assembly

1. Always clean pump thoroughly before each use.
2. Install discharge fitting into discharge tube. Secure discharge fitting to tube by
hooking fitting loop around projection on end of discharge tube.
3. Install knob onto top of discharge tube body by pushing together until knob snaps
onto lip of discharge tube body.
4. Install seal onto bottom of piston. Seal is secure when it snaps onto lip around
bottom of piston.
5. Install gaging collar(s), if needed, and locking collar onto threaded end of piston by
sliding them on. Position locking collar with threading inside locking collar facing seal
at bottom of piston.
6. Install one of the ball valves with ball side seated down into opening in top of piston.
7. Install bottom of discharge tube body onto threaded top of piston with ball valve in
position resting on top of piston. Rotate discharge tube body clockwise until secure
with pump tube assembly.
- 17 -