Work Men WMG3000I Mode D'emploi page 78

Spark Plug Maintenance
The spark plug is important for proper engine operation. A good spark plug should be
intact, free of deposits, and properly gapped. To inspect your spark plug:
1. Pull on the spark plug cap to remove it.
2. Remove the back cover of the generator.
3. Unscrew the spark plug from the generator using the spark plug wrench included
with this product (see figure 18).
4. Visually inspect the spark plug. If it is cracked or chipped, discard and replace
with a new spark plug. We recommend using a spark plug such as F7RTC.
5. Measure the plug gap with a gauge (see figure 19). The gap should be
0.7-0.8mm (0.028-0.031in).
6. If you are re-using the spark plug, use a wire brush to clean any dirt from around
the spark plug base and then re-gap the spark plug..
7. Screw the spark plug back into its place on the generator using the spark plug
wrench. Replace the spark plug cap.
Figure 18- Removing the spark plug
Emptying the Gas Tank
Before storing your generator for extended periods of time, you should drain your
generator of gasoline. To drain the generator of gas:
1. Turn the fuel valve to the "off" position.
2. Remove the fuel filter cup (see "Fuel Filter Cup Cleaning" earlier in this section).
3. Empty the fuel filter cup of any fuel.
4. With a receptacle underneath the generator to catch the gas, turn the fuel valve to
the "on" position. Drain all the gas from the generator.
5. Turn the fuel valve to the "off" position.
6. Replace the fuel filter cup.
7. Store the emptied gasoline in a suitable place.
CAUTION: Do not store fuel from one season to another.
Figure 19- Measuring the spark plug
gap
78