NSK Ti-Max X95EX Manuel D'opération page 12

Masquer les pouces Voir aussi pour Ti-Max X95EX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 41
WARNING
• Immediately after a treatment, the handpiece should be cleaned, lubricated and sterilized. Failure to properly
maintain the handpiece may lead to overheating, causing burn injuries or product failure.
CAUTION
• Do not use the following fluids to wipe, immerse or clean the product; strong/super acid water, strong acid/alkaline chemicals, chlorine-
containing solutions, solvents such as benzine or thinner.
8-1 Preparation
1) Wear eye protection, a mask and gloves to avoid infection.
2) Remove the bur.
3) Disconnect the handpiece from the motor.
8-2 Cleaning
Manual Cleaning (External Surface)
1) Remove debris on the handpiece surface using a brush under running water (at 38°C or less).
DO NOT use a wire brush.
2) Wipe off moisture on the surface using an absorbent cloth.
10

Publicité

Table des Matières
loading

Table des Matières