SEAT
SWITCH
PAD
SLOT
SEAT
PAN
•
Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
SLOT
PAD
FLAT
WASHER
SEAT PAN
BOLT
TAB
TO ADJUST SEAT (See Fig. 4):
•
Grasp adjustment handle and pull up, slide seat to
desired po si tion and release adjustment handle.
NOTE: You may now roll your tractor off the skid. Follow the
instructions below to remove the tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
•
Raise attachment lift lever to its highest po si tion.
•
Release parking brake by de press ing clutch/brake ped al.
•
Place freewheel control in "trans mis sion dis en gaged"
position (See "TO TRANS PORT" in the Op er a tion
section of this manual).
•
Roll tractor forward off skid.
Continue with the instructions that follow.
ASSEMBLY
WIRING HARNESS
Fig. 3
ADJUSTMENT
HANDLE
Fig. 4
ASSEMBLE FRONT WHEEL TO MOWER
(See Fig. 5)
•
Using shoulder bolt, washer and locknut from parts bag, as-
sem ble front wheel to mower as shown. Tighten securely.
TAPE
TO INSTALL MOWER (See Figs. 6-13)
Be sure tractor is on level surface and engage park ing brake.
TAPE
•
Lower attachment lift lever to it's lowest position.
•
Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right.
NOTE: Be sure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under tractor.
7
Fig. 5
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
02965
Fig. 6
A
Fig. 7