Table des Matières
Publicité
Liens rapides
IMPORTANT MANUAL
OPERATOR'S MANUAL
MODEL:
PBGT26H54
GARDEN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
423349 11.13.08 CL
Do Not Throw Away
03090
WARNING:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so can
re sult in serious in ju ry.
Printed in U.S.A.
Publicité
Table des Matières
Manuels Connexes pour Poulan Pro PBGT26H54
Sommaire des Matières pour Poulan Pro PBGT26H54
- Page 1 MODEL: Read this Man u al and follow all Warnings and Safety Instructions. Fail ure to do so can re sult in serious in ju ry. PBGT26H54 GARDEN TRACTOR ALWAYS WEAR EYE PROTECTION DURING OPERATION Visit our website: www.poulan-pro.com 423349 11.13.08 CL...
-
Page 2: General Operation
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and ci den tal starting when setting up,... -
Page 3: General Service
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to • Keep all nuts and bolts tight to be sure the equipment the presence of children. -
Page 4: Table Des Matières
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 4 Gallons and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) •... - Page 5 UNASSEMBLED PARTS Mower Mower Front Wheel (5) Large Retainer (1) 3/4 O.D. Washers Springs - 7/16 (1) Wheel (1) 1-1/4 O.D. Washer (2) Smaller Retainer (1) Locknut Springs - 5/16 (1) Shoulder Bolt 3/8-16 (5) 1-3/16 O.D. Washers Slope Sheet (1) Oil Drain Tube For Future Use Keys...
-
Page 6: Assembly
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping pur- poses. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. (1) 3/4" wrench (1) Utility knife (1) 9/16"... - Page 7 ASSEMBLY ASSEMBLE FRONT WHEEL TO MOWER (See Fig. 3) • Using shoulder bolt, washer and locknut from parts bag, as sem ble front wheel to mower as shown. Tighten securely. FIG. 5 NOTE: Be sure mower side suspension arms (A) are point- FIG.
- Page 8 ASSEMBLY • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Turn steering wheel to position wheels straight for- CHASSIS - Position hole in arm over pin (B) on outside ward. of tractor chassis and secure with washer and retainer • ATTACH FRONT LINK (E) - Work from left side of spring.
- Page 9 ASSEMBLY ✓CHECKLIST BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- FORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instructions have been com plet ed. ✓...
-
Page 10: Operation
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE HIGH NEUTRAL CHOKE IGNITION SWITCH ENGINE START MOWER HEIGHT MOWER LIFT REVERSE ENGINE ON PARKING BRAKE ENGINE OFF OPERATION SYSTEM (ROS) - Page 11 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. FIG.
- Page 12 OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles.
- Page 13 OPERATION • The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth. • For best cutting performance, grass over 6 inches in height should be mowed twice.
- Page 14 OPERATION • To restart movement, slowly release parking brake and brake pedal. • Slowly depress appropriate drive pedal to slowest set- ting. • Make all turns slowly. TO TRANSPORT (See Figs. 13 and 21) When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in free wheel ing po si tion.
-
Page 15: Before Starting The Engine
OPERATION • Insert key into ignition and turn key clockwise to “START” BEFORE STARTING THE ENGINE position and release key as soon as engine starts. Do not run starter continuously for more than fifteen sec onds CHECK ENGINE OIL LEVEL per minute. -
Page 16: Mowing Tips
OPERATION • Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual). • Sitting in the tractor seat, start engine. After the en- gine is running, move throttle control to slow position. Dis en gage parking brake •... -
Page 17: Maintenance Schedule
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH SEASON STORAGE SCHEDULE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure Check Operator Presence & ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness... -
Page 18: Maintenance
MAINTENANCE TRACTOR BLADE CARE For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- worn, bent or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade approved by the manufacturer of If tractor requires more than five (5) feet to stop at highest your tractor. -
Page 19: Engine Lubrication
MAINTENANCE TO CHANGE ENGINE OIL (See Figs. 24 and 25) • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush Determine temperature range expected before oil change. until bright. All oil must meet API service classification SG-SL. •... -
Page 20: Spark Plugs
MAINTENANCE DECK WASHOUT PORT (See Fig. 26) ENGINE OIL FILTER Your tractor’s deck is equipped with a washout port on Replace the engine oil filter every season or every other its surface as part of its deck wash system. It should be oil change if the tractor is used more than 100 hours in utilized after each use. -
Page 21: Service And Adjustments
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST - MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. •... - Page 22 SERVICE AND ADJUSTMENTS • Go to side of mower you wish to adjust. FRONT-TO-BACK ADJUSTMENT (See Figs. 31 and 32) • With a 3/4" or adjustable wrench, turn lift link adjust- IMPORTANT: Deck must be level side-to-side. ment nut (A) to the left to lower the mower, or, to the To obtain the best cutting re sults, the mower blades should right to raise the mower.
- Page 23 SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT TO CHECK BRAKE If tractor requires more than five (5) feet to stop at highest MOWER DRIVE BELT REMOVAL (See Fig. 33) speed in high est gear on a level, dry concrete or paved •...
- Page 24 SERVICE AND ADJUSTMENTS WASH ERS RE TAIN ING RING AXLE COVER SQUARE KEY (REAR WHEEL ONLY) FIG. 35 TO START ENGINE WITH A WEAK BATTERY (See Fig. 36) WARNING: Lead-acid batteries gen- er ate ex plo sive gases. Keep sparks, flame and smoking ma te ri als away from bat ter ies.
- Page 25 SERVICE AND ADJUSTMENTS REPLACING BATTERY (See Fig. 37) TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 38) WARNING: Do not short battery ter mi nals by allowing a wrench or any other object to contact both terminals at • Raise hood. the same time.
-
Page 26: Storage
STORAGE Immediately prepare your tractor for storage at the end ENGINE of the season or if the tractor will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS WARNING: Never store the trac tor with FROM FORMING IN ES SEN TIAL FUEL SYSTEM PARTS SUCH gas o line in the tank inside a building AS CARBURETOR, FUEL FIL TER, FUEL HOSE, OR TANK... -
Page 27: Trou Ble Shoot Ing
TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4. - Page 28 TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine dies when 1. Reverse operation system 1. Turn ignition key to tractor is shifted (ROS) is not "ON" while ROS "ON" position. into reverse mower or other attachment See Operation section. is engaged. Engine continues to 1.
-
Page 30: Warranty
LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi- als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, without charge for parts or labor incurred in replacing parts, any part which we find to be defective due to materials or workmanship. -
Page 32: Parts And Service
PARTS AND SERVICE This product has been expertly en gi neered and carefully manu fac tured to rigid quality stan dards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. For Parts and service, contact our authorized distributor: call 1-800-849-1297 •...