Output Contacts - DAB ESY I/O Guide Rapide

2.8 Output contacts

The connections of the outputs listed below refer to the terminal board indicated with screen printing O1, O2 and CA.
Table 3 describes the characteristics and limits of the output contacts.
Characteristics of the output contacts
Type of contact
Max. bearable voltage [V]
Max. bearable current [A]
Max. accepted cable section [mm²]
The correspondences between relays and outputs are described below:
An example of a connection is shown below, on output O1 with a 230V load.
ENGLISH
Figure 5: Input Status Page
Table 4: Characteristics of the output contacts
Label
RL6
RL7
RL8
RL9
Table 5: Relay Output correspondence
NO (Normally open)
230 VAC
5 -> resistive load
2.5 -> inductive load
2.5
Corresponding Output
O1
O2
O3
O4
19