Dibo JMB-S Mode D'emploi page 91

19. Reel
The JMB-S will be standard equipped with a high pressure reel.
Always secure/block the reel after use and before transporting the trailer.
Please note for possible risk of heat to the high pressure coupling of the reel at the use of the burner.
Always unroll the reel hose completely during spraying activities to ensure an optimal performance!
Disconnect the high pressure coupling: loosen the spray gun coupling from the reel frame coupling.
Couple the high pressure gun to the spray lance before starting spray activities.
Lock the spray gun coupling again tto the reel frame coupling after use.
20. Support arm
The support arm is mounted at the back, underneath the trailer on the light bar.
Watch out for the crossover point of the support arm at a filled/unfilled water tank.
Pulling out the support arm can be done by the red handle, the support arm folds now, set the support arm fixed
to the ground by the central bolt (circled in red on photo 3) and with aid of a wheel bolt/crank.
Pull back the red handle and push the support arm upwards to return to fold.
Pay also attention to compensation of the spring on the axles. If the supports are lowered completely, they will
take the entire weight of the load and can become damaged.
On soft ground, suitable sheet/plate material has to be laid under the supports.
21. Pressure valve
The pressure control valve has a fixed default setting, this is not adjustable.
JMB-S : REV A DiBO n.v. 91