Vulcan GHCB40C Manuel D'installation Et D'utilisation page 22

COOKING
It is not necessary to preheat the IR Model broilers before using, nor is it necessary to keep the gas
on a low setting when not in use. Broiling temperatures are reached within 90 seconds. Burner life will
be extended if the burners are turned off between cooking periods.
Select the desired grid position and gas setting. It is recommended that gas input be reduced first when
lower grid temperatures are desired. Further reduction in grid temperatures, if necessary, can then be
obtained by lowering the grid position to any one of the several grid positions.
Pull the broiler grid handle straight out to slide the grid assembly out for loading. After loading product,
pull the grid handle slightly up and push straight back to return the grid assembly to the cooking
chamber.
USING THE BROILER
Initiation of the cooking cycle and shutdown procedures are as follows:
Models IR2 and GHIR44
To Start
1. Flip the toggle switch, located on the lower front center panel, to the ON position.
2. After the red indicating light comes on, turn the burner valve to the desired setting.
Nightly Shutdown
1. Turn the burner valve OFF.
2. Flip the toggle switch to the OFF position.
Complete Shutdown
Perform Steps 1 and 2 of nightly shutdown instructions, then turn pilot B valve and main gas line valve
OFF.
Model GHCB40
To Start Broiler
Turn the burner valve to the desired setting.
To Start Oven
1. Turn oven burner knob to ON.
2. Set thermostat dial to desired temperature.
Complete Shutdown
1. Turn burner valve OFF.
2. Turn oven burner knob to OFF and extinguish the pilot.
3. Turn main gas valve OFF.
– 22 –