Power Head Assembly; Insert Locking Hose - Workshop WS0500ASH0 Manuel Du Propriétaire

Power Head Assembly

1. Line up front of power head assembly
with vacuum port located on the front
of the drum, as shown.
2. Place power head assembly on top of
drum.
3. Be sure power head assembly
completely covers the top of the drum
so leakage does not occur.
4. Rotate the latches on each side of the
drum, positioning the latch hooks over
the lip of the power head assembly.
5. Snap down the bottom edge of the
latches to secure the power head
assembly to the drum.

Insert Locking Hose

NOTE: Use ONLY the metal lined hose
and metal accessories provided with this
Ash Vac.
1. Align hose tabs with inlet and insert
the locking end of the hose into the
inlet of the Vac drum, as shown.
2. Rotate the hose clockwise to lock into
place.
3. To remove the hose from the Vac,
rotate the locking hose counter-
clockwise and pull the hose out of the
Vac inlet.
VAC ASSEMBLY
(continued)
Power Head
Assembly
Lip
ROTATE
LATCH
UP
Hose Locking End
Locking Hose (Metal
Lined) with LED Light
8
Power Head
Assembly
Vacuum
Port
Drum
Latch
SNAP
DOWN
LATCH
Inlet
ROTATE HOSE
CLOCKWISE
TO LOCK