Installing The Boom - Cannon UNI-TROLL 10 STX-TS Manuel De L'utilisateur

Decks from 1/4" to 7/16" thick
Where access to the underside of the deck is not available, the mounting
base can be attached to the deck using wellnuts. Use the base as a
template to mark locations and drill four wellnut clearance holes. Mount
the base using four 1/4-20 x 1-1/2" truss head screws and four wellnuts.
Tighten the screws so the wellnuts are fi rmly compressed as pictured.
Decks thicker than 7/16"
For decks thicker than 7/16", or where the underside of the deck is
accessible, mount the base with screws, nuts, and washers. Use the
base as a template to mark the locations and drill four 9/32" holes. Use
four 1/4-20 x 2" truss head screws and four each fl at washers and nuts.
Fasten the base to the deck as pictured.
NOTE: Wellnuts SHOULD NOT be used on decks thicker than 7/16".
NOTE: When using the telescopic boom, we strongly recommend the
use of a deck plate on all boats to provide adequate stability for the
downrigger.
Low-Profi le Swivel Base
To mount the Low-Profi le Swivel Base, follow the same procedure as for the deck
plate with this exception: use four 1/4"-20 x 1-1/2" truss head screws to fasten the
mounting base and four additional 1/4"-20" x 2-1/2" truss head screws to attach the
swivel base tothe boat deck.

INSTALLING THE BOOM

1. Insert boom into frame (Figure 1) and line up holes in boom with holes in frame.
NOTE: Easi-Troll units require the included boom adapter.
2. Remove 1/4-20 x 2" bolt and 1/4-20 nylon locknut from included hardware bag assembly and insert the locknut into the
hex pocket on the nose of the frame. Insert 1/4-20 x 2" bolt into reel side of frame nose. (Figure 2)
3. With a Phillips head screw driver, thread bolt into nylon locknut from step 2 (Figure 2). Tighten bolt until the end of the
bolt is fl ush with the top of the nut. (Figure 3)
Figure 1
©2015 Johnson Outdoors Marine Electronics, Inc.
ASSEMbLy & INSTALLATION
Figure 2
base
Deck
1/4-20" screw
Wellnut
Decks from 1/4" to 7/16" Thick
base
Deck
1/4-20" screw
Washer & Nut
Decks Thicker Than 7/16"
Low-Profi le Swivel Base
Figure 3
cannondownriggers.com | 7