Quick Installation - NEC MultiSync LCD1920NX Mode D'emploi

Quick Installation

• Make sure the computer is turned off.
• Attach the female end of the power cord (Indication E) to the AC adapter
(Indication D), then plug the AC adapter connector to the power "DC-IN
(Indication A)" jack of the LCD monitor.
• When using a power cord, plug the male end into the wall socket.
• Plug one end of the 15 pin D-SUB signal cable (Indication F) in the "D-SUB"
video signal connector (Indication B) of LCD monitor. If using a digital signal,
plug one end of the 24 pin DVI-D signal cable (Indication G) in the "DVI-D"
video signal connector (Indication C) of LCD monitor.
• Turn on the computer.
• Turn on the LCD monitor.
• Before operating the monitor, please refer to page 6 "Operations" first.
A
B
E
D
A. DC In
B. D-SUB
C. DVI-D
D. AC Adapter
NOTE : When operating this LCD monitor with an AC125-240V power source,
please refer to "Recommended Use" for proper power cord selection.
Use supplied AC adapter.
C
G
F
E. Power Cord
F. D-SUB Signal Cable
G. DVI-D Signal Cable (not included)
4
Connector Cover