(EN) ENGLISH
CHARACTERISTICS
• Light source: 26 LED diodes
• Power: 3W
• Colour temperature: 2700K (CRI >90)
• Power source: 5V DC, 1A
• IP20
WARNINGS
Please read this manual thoroughly before using the product.
Keep this manual until the product comes to the end of its
life cycle.
This light is intended for indoor use. Do not expose to the
outdoor environment. Make sure liquid and dust do not get
inside.
The light source for this product must only be replaced by the
manufacturer, their technical service department or a quali-
fied technician.
Never try to open or disassemble the light. There are no useful
parts inside the light.
Never expose the light to extreme temperatures.
If you notice that the charger cable provided is in poor con-
dition, throw it away and replace with another cable of the
same type.
USE
Touch the on/off symbol on the base to switch on the light.
The light source will activate 25% of its maximum power. On
touching the on/off switch a second time, 50% of its maxi-
mum power will be activated, the third time 75% and the four-
th 100%. Touch the base again to turn off the light.
Rotate and tilt the light head to suit your requirements and
obtain optimum visual comfort.
BATTERY AND CHARGE
This product contains a lithium ion battery (Li-ion) with the
following characteristics: 4 cells, 3.7V, 10000 mAh.
The battery is not included in the product warranty
The light can be used with a fully charged battery for approxi-
mately 10 hrs. at 100%, 12 hrs. at 75%, 18 hrs. at 50% and 30
hrs. at 25%.
When the battery charge is low, a flashing red warning light
will be activated. When the battery has no charge left, the
luminaire will turn off. Charge the battery at this time.
On-Off
To charge the battery, connect the charger provided to the
light's charger connector (B) and plug into the mains. A red
warning light will be activated without flashing. In normal
circumstances, charging an empty battery until completely
charged should take approximately 13 hours. The warning
light will turn green when the battery is fully charged. Dis-
connect the charger from the luminaire and unplug from the
mains.
In normal conditions, the battery life is approximately 600 dis-
charge and recharge cycles.
When you notice that battery capacity decreases signifi-
cantly, it is nearing the end of its useful life cycle. When the
light will not switch on and cannot be charged up, the battery
has been completely used up. If you want to exchange the
old battery for a new one, please contact the technical ser-
vice department or manufacturer. Alternatively, throw away
the light by taking it to a recycling centre. Never attempt to
disassemble the light or expose the battery.
To prolong the battery life, please follow these simple recom-
mendations:
• Before using the product for the first time, charge up the
battery to its full capacity. Connect the charger provided
to the luminaire and plug into the mains. Leave to charge
for 24 hours.
• Do not leave the battery uncharged for long.
• If it will be a long time until you use the light again, do not
store either fully charged or fully uncharged.
• Do not charge up the battery until it is empty (flashing red
warning light). Once you start to charge it, do not stop until
it is completely charged (green light).
• Do not leave the battery charging for long once it is fully
charged (green light).
• Do not charge up the light in closed or overly hot environ-
ments.
• Always use the charger provided. If you do not have the
charger to hand, you can use any charger that has a
USB -C connector and a minimum output of 5V DC and 1A
(mobile phone or tablet). Do not use a computer USB port
to charge it.
CLEANING
Do not use solvents or abrasive products to clean the light. It
could damage the finish. Wipe with a damp cloth to clean.
USEFUL LIFE CYCLE AND RECYCLING
At the end of the light's useful life cycle, take it to a collection
point to be recycled. Never throw away in a rubbish bin as it
contains products that are harmful for the environment.
(B)
(A)