Braun MultiQuick 9 MQ 9037x Instructions page 7

English
Our products are engineered to meet the highest
standards of quality, functionality and design.
We hope you thoroughly enjoy your new Braun
appliance.
Before use
Please read instructions carefully and
completely before using the appliance.
Parts and Accessories
1 Pilot light
2 Safety button
3 Smart Speed switch / variable speeds
4 Motor part
5 EasyClick Plus Release buttons
6 ActiveBlade shaft
7 Beaker
8 Whisk accessory
a Gearbox
b Whisk
9 Puree accessory
a Gearbox
b Puree shaft
c Paddle
10 2-cup / 500 ml chopper accessory «ca»
a Lid (with gear)
b Chopping blade
c Chopper bowl
d Anti-slip rubber ring
Clean all parts before using for the first time
– refer to «Care and Cleaning».
Pilot Light
The pilot light (1) shows the status of the appliance,
when it is connected to an electrical outlet.
Pilot light Appliance / Operating status
Flashing red Appliance is ready for use.
Solid green Appliance is released (switch re-
lease button is pressed) and can
be switched on.
Solid Red Early warning about overheating.
Motor slows down, step by step,
till shut off. Let the device cool
down. It is ready for use again
when the pilot light fl ashes red.
If the maximum speed decreases under high load
and long running time you can still finish your
preparation, however you should let the appliance
cool down afterwards.
How to Use the Appliance
Smart Speed Switch for
Variable Speeds
One squeeze, all speeds. The more you press, the
higher the speed. The higher the speed, the faster
and finer the blending and chopping results.
One handed operation: the Smart Speed switch (3)
allows you to turn on the appliance and control the
speed with one hand.
Operating your Hand Blender
First use: Remove the transportation lock from the
motor part (4) by pulling it at the red strap.
Switching On (A)
The appliance comes equipped with a safety button
for releasing the Smart Speed switch. To safely turn
it on, follow these points:
• Press the safety button (2) with your thumb. The
Pilot Light will turn solid green.
• Immediately press the Smart Speed switch and
adjust to the desired speed. Note: If the Smart
Speed switch is not pressed within 2 seconds,
the appliance cannot be switched on for safety
reasons. The pilot light will flash red. To switch
the appliance on, start again with first step.
• During operation you do not need to keep the
safety button pressed.
ActiveBlade Shaft (B)
The hand blender is equipped with an ActiveBlade
shaft, which enables the knife extend to the bottom
of the bell. The adjustment is made automatically by
pressure required in blending tasks, especially
suited to mix hard foods e.g raw fruits and
vegetables.
It is also perfectly suited for preparing dips, sauces,
salad dressings, soups, baby food, as well as
drinks, smoothies and milkshakes.
For best results, use the highest speed.
Assembly and Operation
• Attach the ActiveBlade shaft (6) to the motor part
until it clicks.
• Place the ActiveBlade shaft into the mixture to be
blended. Then switch the appliance on as
described above.
• Blend ingredients to the desired consistency
using a gentle up-and-down motion. Depending
on the pressure applied, the ActiveBlade shaft
will depress and blade will extend.
• After use, unplug the hand blender and press the
release buttons (5) to detach the ActiveBlade
shaft.
7