Inventum AKB9015ZWA Manuel D'utilisation page 31

INSTALLING THE RECIRCULATION SET
Note:
The recirculation set is optional.
1. Loosen the screws (A) of the support of the shaft.
2. Install the recirculation set (B) to the support. Use the hooks (C).
3. Tighten the screws.
PREPARING THE INSTALLATION OF THE HOSE FOR EXTRACTION MODE
The hose can be installed either via the wall or via the ceiling.
Preparing the installation of the hose via the wall
1. Drill a hole (A) in the wall with a diameter of 160 mm.
Preparing the installation of the hose via the ceiling
1. Drill a hole (A) in the ceiling with a diameter of 160 mm.
2. Make sure that the hole is positioned a minimum of 100 mm (B) from the wall.
PREPARING THE INSTALLATION OF THE MAINS SOCKET
1. Mark the position for the mains socket. Obey these requirements:
a. The width of the mains socket must be the width of the shaft (A) minus 20 mm.
b. The position of the mains socket must be at a minimum of 10 mm (B) below the support of
the shaft and at a minimum of 300 mm (C) above the support of the cooker hood.
INSTALLING THE APPLIANCE
Preliminary requirements
• Screws Ø 4 x 16 mm (3x)
• Screwdriver
Warning:
Two people are required to install the appliance.
Procedure
1. Put the appliance (A) on the support (B).
2. Fix the screws (C) and (D) to fasten the appliance to the support. Use the screwdriver.
INSTALLING THE HOSE
1. Install the hose (A) to the appliance (B) and to the exhaust opening (C). Use the hose clamps.
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 9)
(Figure 10)
(Figure 11)
English • 31