Control Panel; Extra Functions - Inventum AKB9015ZWA Manuel D'utilisation

CONTROL PANEL

(Figure 2)
A Down button
B Up button
C Display
Item
Down button
Up button
Display
Timer button
Lamp button
WORKING PRINCIPLE COOKER HOOD
(Figure 3)
The appliance is used for handling the air of cooking fumes.
The appliance can be installed in two different ways.
Extracting (A)
The cooking fumes are extracted outside.
Warning:
Never connect the pipe to a duct that contains gas or other fuels.
Recirculating (B)
The cooking fumes go through a carbon filter or a plasma filter. The filter purifies the fumes and recirculates these
back to the kitchen.
A good outflow of the air is necessary.
Extra information
• Note:
New houses may no longer vent outside.
• For recirculation, it is necessary to use carbon filters or a plasma filter. For more information on the differences
between carbon and plasma filters go to the website www.inventum.eu.
• Attention:
The carbon filters and plasma filters are not included. You need to order these separately.

EXTRA FUNCTIONS

Refresh control
During the refresh control function, the appliance goes on every 10 minutes on the lowest speed to refresh the air in
the kitchen / room. After 24 hours the refresh control function stops automatically.
D Timer button
E Lamp button
Function
• To stop the appliance.
• To decrease the speed or set time.
• To activate the smell control function.
• To start the appliance.
• To increase the speed or set time.
• To activate the refresh control function.
To show the set speed level and the set time.
• To delay stopping the appliance.
• To reset a saturation indicator.
To activate/deactivate the lamps.
English • 29