Intended Use; Improper Use; Technical Data; Transport - Leister HEMTEK ST Notice D'utilisation

Caution

1.1 Intended Use

The HEMTEK ST / K-ST is designed for professional indoor utilization for welding tarpaulins.
Use only original Leister spare parts and accessories because otherwise no warranty or guarantee claims can be
asserted.
HEMTEK ST welding processes and material types:
• Hem, hemstitch and fillet welds of thermoplastic materials
• Welding widths 20, 30, 40 mm
HEMTEK K-ST welding processes and material types:
• Flap-piping-welding of thermoplastic materials
• Welding width 8 mm

1.2 Improper Use

Any other use or any use beyond that described is deemed as improper use.

2. Technical Data

Nozzle width
Nominal voltage
Nominal voltage
Frequency
Temperature, stepless
Air volume, stepless
Drive, stepless
Emission level
Dimensions (L × W × H)
Weight
Mark of conformity
Protection Class I
Subject to change without prior notice.

3. Transport

Comply with applicable national statutes regarding the carrying or lifting of loads.
The weight of your HEMTEK ST / K-ST excluding table fastening is 20 kg.
Two persons are required for transportation with the table fastening.
Protect the device from moisture and wet conditions.
For transporting the hot air welder two people are needed.
When working on the open system, do not wear clothing such as scarves,
shawls, or neckties. Tie up long hair or protect it by wearing headgear.
HEMTEK ST
120 V
mm 20/30/40
V~
120
W
1 800
Hz
°C
m/min.
L (dB)
pA
mm
433 × 350 × 600
kg
27 (including table fastening)
HEMTEK ST
230 V
30/40 20
220 – 240 220 – 240
3 450 2 350
50 / 60
100 – 650
1 – 10
0,8 – 12
70 (K = 3 dB)
HEMTEK K-ST HEMTEK K-ST
120 V 230 V
8 8
120 220 – 240
1 800 2 350
50 / 60
100 – 650
10
0,8 – 12
70 (K = 3 dB)
433 × 350 × 600
27 (including table fastening)
19