Fellowes POWERSHRED P-48C Mode D'emploi page 3

OPERATION
Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.
Continuous operation:
3-5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-5 minutes will trigger
15-minute cool down period.
Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide towards front of shredder.
15
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or
all of the below procedures.
1
2
Set to Reverse (R)
for 2-3 seconds
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 3 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
PAPER
1 1
Set to Off (O) and
plug in
CARD
1 1
Set to Off (O) and
plug in
3
Alternate slowly back and forth
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
1 3
1 2
Check paper amount Set to Auto-On (I)
1 2 3
Set to Auto-On (I) Hold card at edge
4 5
Set to Off (O) Gently pull uncut
and unplug paper from paper
entry. Plug in.
2
3
Set to Reverse (R)
* Apply oil
across entry for 2-3 seconds
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
for any consequential or incidental damages attributable to this product. This warranty gives you
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
1 5
4
Feed into paper
entry and release
1 5
4
Feed into center of
entry and release
Shredder doesn't start:
6
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in
Set to Reverse (R)
unlock position
Set to Off (O)
Set to Off (O)
3