KitchenAid KICA0WH Mode D'emploi page 8

USING THE ICE CREAM MAKER ATTACHMENT
Position the drive assembly onto the
mixer so that side B is closest to the
3
beater shaft. Slide drive assembly
onto the motor head until it will not
slide any further.
Raise the bowl to engage the dasher
with the drive assembly before
mixing. If the drive assembly doesn't
5
engage the dasher, slide the drive
assembly either back or forward until
it does engage the dasher properly.
Plug the Stand Mixer into a grounded
6
3 prong outlet.
8 | USING THE ICE CREAM MAKER ATTACHMENT
W11111749A_EN_v07.indd 8
When properly assembled, the outer
curved edges of the drive assembly
should center on the motor head. If
they are not centered, slide the drive
4
assembly either back or forward until
it is centered on the motor head.
Make sure the drive assembly is
securely in place by pressing upward.
5/31/17 9:18 AM