Entering Stations Into Memory Automatically (The Automatic Preset Mode: Asm); Manually Setting Stations Into Memory; Preset Station Scan - Eclipse CD3000 Manuel D'utilisation

Operation
Entering stations into memory
automatically
(The automatic preset mode:
ASM)
Press the [SEL] button for more
1
than two seconds until a beep is
heard.
The automatic preset mode starts.
The [ASM ON] indicator on the screen
flashes, and stations are automatically
entered in memory under buttons [1] to
[6].
These buttons are called
buttons.
ATTENTION
• Pressing the preset buttons ([1] to [6])
allows you to make one-touch station
selections. The frequency of the selected
station is indicated on the display.
• When a new station is set in memory, the
station previously set in memory will be
deleted.
• If there are fewer than six receivable
stations, the stations set in the remaining
buttons will be retained.
24
preset
b
Manually setting stations into
memory
This section covers the setting of stations in
memory under the numbered buttons.
Turn the [SEL] button to the right
1
or left to tune to the station to be
entered in memory.
Select any button, from [1] to [6],
2
and press it for more than two
seconds.
The tuned station is now memorized
and set in the selected button.
Repeat the
additional manually tuned stations in
memory, in turn, for buttons [1] to [6].
These buttons are called the preset
buttons.

Preset station scan

This function enables reception of all the stations
in the preset buttons for five seconds each.
Press the [SEL] button for less
1
than two seconds.
[P SCAN] will appear on the display,
and stations stored under preset
buttons [1] to [6] will be played for
five seconds each.
To stop the preset scan mode at a
2
desired station, press the [SEL]
button again.
The receiver will stay tuned to the
desired station.
procedure to set