Charge Battery Pack; Inserting The Drive Battery - Carson On-Road Chassis 1:5 6S Brushless Mode D'emploi

cHarge battery PacK

Beware:
For charging the battery, only use the recommended charger.
Please consider the advice of the enclosed instructions.
Charging procedure:
1 Connect the charger using the power lead supplied.
2 Connect it to a standard 100-240V socket. If all of the LEDs flash
alternately for one second, the charger is ready to use.
3 Now connect the battery pack to the charger using the XHP
balancer plug.
4 The charging process has now started.
5 The charger has a charging indicator lamp with four LEDs to
indicate the status.
1st LED – battery pack has 25% capacity,
2nd LED – 50%,
3rd LED 75%. If all four LEDs glow, the battery pack is fully
charged.
Error indication:
All four LEDs flash during the charging process (please check your
battery pack).
InSertIng tHe DrIVe batterIeS
1 Insert the batteries into the designated compartment.
2 Secure it with the available hook-and-loop strap.
Check it for firm seating !!!
Advice
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before
being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Regular examination of transformer or battery charger for any
damage to their cord, plug, enclosure and other parts.
GB // 16