Notes On Safety - Grizzly Tools EKS 2440 QT Traduction De La Notice D'utilisation Originale

Weight
(without guide rail and chain)........... 4.7 kg
Weight (with guide rail and chain) ... 5.5 kg
Oiltank ............................................125 ml
Chain bar ...Oregon 16" DOUBLE-GUARD
Chain ...........................Oregon 91PX057X
Chrome cutting teeth, low-kickback
Chain link separation...................10 mm
Chain width ................................1.3 mm
Teeth of the sprocket chain wheel ........6
Length of the chain bar .................460 mm
Sawing length ...............................395 mm
Acoustic pressure level
(L ) ...................... 93.0 dB(A); K
pA
Sound power level (L
measured .. 105.36 dB(A); K
guaranteed ............................108 dB (A)
Vibration (a ) .............7.5 m/s
h
The sound pressure level at the work-
place can exceed 80 dB (A). In such cas-
es, the operator must take noise control
measures (e.g. wear suitable ear protec-
tion and take regular breaks).
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
160SDEA041-112364
=3 dB
pA
)
WA
= 2.39 dB
WA
; K=1.5 m/s
2
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the impact of vibrations
as low as possible. Examples of
measures to reduce the impact of
vibration include wearing gloves
when using the tool and limiting
the time spent working with the
tool. All parts of the operating cycle
have to be taken into account, for
example, times in which the elec-
tric tool is switched off and such
2
times where it may be switched on
but is still running without any load.
This device is designed for opera-
tion on a power supply network
with a system impedance Zmax
at the transfer point (domestic
connection) of a maximum of
0.107 Ohms.
The user must ensure that the de-
vice is operated only on a power
supply network that fulfils this re-
quirement.
If necessary, the local power sup-
ply company can be asked for the
system impedance.

Notes on safety

This section deals with the basic safety
regulations while working with the electric
chainsaw.
GB
123