Technical Data; Notes On Safety - Grizzly Tools EKS 2240 QTX Traduction De La Notice D'utilisation Originale

GB
The chainsaw is equipped with various
protection fittings for the protection of the
user.
Refer to the following descriptions for the
function of control elements.

Technical Data

Electrical chainsaw ........EKS 2240 QTX
Rated input voltage.............230 V~, 50 Hz
Input power ................................... 2200 W
Safety class ........................................
Protection type................................... IP20
Chain speed ................................13.6 m/s
Weight
without guide rail and chain.......... 4.6 kg
with guide rail and chain...............5.4 kg
Chain bar Oregon 160SDEA041 (112364)
Chain ............................Oregon 91P057X
Chain link separation......3/8" (9.53 mm)
Chain width ............................. 1.27 mm
Teeth of the sprocket chain wheel ....... 7
Sawing length ......................max. 395 mm
Length of the chain bar ................ 457 mm
Sound pressure level
(L ) ..................96.0 dB(A); K
pA
Sound power level (L
measured ...... 108.0 dB(A); K
guaranteed ......................... 112.0 dB(A)
Vibration at the handle
(a ) ...................... 6.97 m/s
h
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
134
= 3.0 dB
pA
)
WA
= 3.0 dB
WA
; K= 1.5 m/s²
2
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
II working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched
on but running without any load).
This device is designed for opera-
tion on a power supply network
with a system impedance Zmax at
the transfer point (domestic con-
nection) of a maximum of 0.107
Ohms. The user must ensure that
the device is operated only on a
power supply network that fulfils
this requirement. If necessary, the
local power supply company can
be asked for the system imped-
ance.

Notes on safety

This section deals with the basic safety
regulations while working with the electric
chainsaw.
An electric chainsaw is a danger-
ous device, which can cause
serious or even fatal injuries with
incorrect or careless use. Thus,
for your own safety and the safety
of others, you should always take