Slugger JMU 137 QW Mode D'emploi page 8

OBJ_BUCH-0000000261-003.book Page 8 Thursday, April 27, 2017 7:47 AM
en
8
Intended use of the power tool:
Magnetic core drill unit for drilling with core
drill bits and solid drill bits, reaming, counter-
sinking and tapping on materials with surfaces
suitable for magnets in weather-protected
environments using the application tools and
accessories recommended by Slugger.
Operation of the power tool off power generators.
This power tool is also suitable for use
with AC generators with sufficient power
output that correspond to the Standard
ISO 8528, design type G2. This Standard is
particularly not complied with when the so-
called distortion factor exceeds 10 %. When
in doubt, please refer to the generator
instruction/specification guide.
Symbols.
Symbol, character
WARNING
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
Explanation
Make sure to read the enclosed documents such as the
Instruction Manual and the General Safety Instructions.
Observe the instructions in the text or graphic opposite!
Observe the instructions in the text or graphic opposite!
Before commencing this working step, pull the power plug
out of thesocket. Otherwise there will be danger of injury if
the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Do not touch the rotating parts of the power tool.
Warning against sharp edges of application tools, such as the
cutting edges of the cutter blades.
Danger of slipping!
Danger of crushes or contusions!
Caution! Falling objects!
Hot surface!
Operating the power tool off
power generators whose no-