Slugger JMU 137 QW Mode D'emploi page 20

OBJ_BUCH-0000000261-003.book Page 20 Thursday, April 27, 2017 7:47 AM
en
20
Adjusting the stroke range (figure 11).
Hold the power tool firmly
CAUTION
with one hand when releasing
the two fastening levers.
To move the fastening levers over each other,
pull a fastening lever outward and then turn
the fastening lever in 45° steps.
Loosen both fastening levers with the other
hand.
Adjust the desired stroke range.
Tighten both fastening levers again.
Fig. 11
2.
2.
1.
4.
2.
4.
2.
3.
1.
1.
3.
2.
4.
2.
4.