Slugger JMU 137 QW Mode D'emploi page 13

OBJ_BUCH-0000000261-003.book Page 13 Thursday, April 27, 2017 7:47 AM
Assembly instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Mounting the spoke handle
(figure 3).
The hub assembly can be mounted on either
side.
Loosen the screw using a hex key.
Remove the spoke handle.
Mount the spoke handle on the other side
and tighten the screw using a hex key.
Fig. 3
5 mm /
3/16 in
1.
3.
en
13
2.
5 mm /
3/16 in
4.