Publicité
Les langues disponibles
Les langues disponibles
reduce interference.
(100µF-2200µF / voltage as operating voltage +5V / 105° C, low internal
resistance)
Safety overheating cut-off (not Pico 8):
If the speed controller's output stage threatens to overheat, a safety temperature cut-off switches off
the motor function until it has cooled down to a safe level. After cooling down, you can activate the
motor function again. To do this, you have to move the transmitter stick to "motor off position".
Under voltage cut - off:
If the battery reaches the under voltage cut-off, the speed controller will switch-off the motor. If the
battery voltage gets high enough again, you can activate the motor function. To do this, you have to
move the transmitter stick to "motor off position". If you use the speed controller with the BEC-
System, make sure to land your model as soon as possible, before the battery voltage is too low for a
safe receiver operation.
How to switch on and activate the speed controller (The speed controller does only beep with
connected motor):
1. switch on the transmitter
2. connect the battery and switch on the speed controller
3. the speed controller will beep two times.
4. If your transmitter stick is at the position „neutral" or "brake" , the speed controller will beep three
times and is now active.
5. If the speed controller fails to detect the brake range, it is likely that you need to reverse the throttle
channel; alternatively you may have reduced the throttle servo travel to less than 100%. If you don't
like the factory setting of the speed controller, you should follow the next programming steps.
Programming the speed controller to your transmitter stick and activating/deactivating the
brake:
Attention: The soft start time will change with your servo travel. If you choose the servo travel 100%
the soft start time is slow. If you choose a smaller servo travel (f. e. 50%) the soft start time is faster.
Choose the servo travel, as you like the soft start time most.
Programming the speed controller with the SET – button:
1. switch on the transmitter, move the transmitter stick to the position „neutral" (motor off)
2. connect the battery to the speed controller and switch on the speed controller
3. you will hear two beeps.
4. push the SET - button
5. you will hear one beep.
6. hold the transmitter stick in the position „neutral" (motor off), until you hear two beeps (after
approx. 2 sec.)
7. a) If you don't want to have the brake, move the transmitter stick within the next 3 sec to the
position „ full throttle" and hold
the stick in this position until you hear three beeps.
b) If you need the brake, move the transmitter stick within the next 3 sec to the position „full
throttle" and immediately next to the position "full brake" and hold the stick at the position " full brake"
until you hear three beeps.
8.) The speed controller will be activated, as soon as your transmitter stick is in position „neutral" or
„brake" and your speed controller did beep three times.
Publicité
