Important Safeguards - shark GI460A Guide Du Propriétaire

IMPORTANT SAFEGUARDS

IMPORTANT: Be sure that dual voltage selector is in the correct position before
operating the garment steamer/iron. Before plugging in, read the
information about dual voltage operation in the instruction manual.
This appliance was set at the factory to operate at 115/120 V., 60 Hz.
When using your garment steamer/iron, basic safety precautions should always be
followed, including the following:
1. Read all instructions carefully.
2. Use garment steamer/iron only for its
intended use.
3. To protect against risk of electrical
shock, do not immerse the garment
steamer/iron in water or other
liquids. Always turn the garment
steamer/iron to "MIN"before
plugging in or unplugging from
outlet.
4. Never yank cord to disconnect from
outlet. Grasp plug and pull to
disconnect.
5. Do not allow cord to touch hot
surfaces. Let garment steamer/iron
cool completely before putting away.
6. Always disconnect garment
steamer/iron from electrical outlet
when filling with water, emptying, or
when not in use.
7. Do not operate garment steamer/iron
with a damaged cord, or after the
appliance has been dropped or
damaged in any manner. To avoid
the risk of electric shock, do not
disassemble the appliance. Return
the unit to EURO-PRO Operating
LLC for examination and repair.
Incorrect reassembly can cause the
risk of electric shock when the
garment steamer/iron is used.
SAVE THESE INSTRUCTIONS
For Household Use Only
POLARIZED PLUG
This appliance has a polarized plug (one blade is
:
wider than the other). As a safety feature, this plug
will fit into a polarized outlet only one way. If the
plug does not fit fully into the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this safety
feature.
8. Close supervision is necessary for
any appliance being used by or near
children. Do not leave garment
steamer/iron unattended while
connected or on an ironing board.
9. Burns can occur from touching hot
metal parts, hot water or steam. Use
caution when you turn a steam iron
upside down; there may be hot
water in the reservoir.
10. Loop cord loosely around garment
steamer/iron when storing.
11. This appliance is for household
use only.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not
operate another high-wattage
appliance on the same circuit.
2. If an extension cord is absolutely
necessary, use a 10-ampere cord.
Cords rated for less amperage may
overheat. Use care to arrange the
cord so that it cannot be pulled or
tripped over.
1 Rev. 01/08A
GETTING TO KNOW YOUR GARMENT STEAMER / IRON
Technical Specifications
Voltage: 115/230 V., 60/50Hz.
Power: 800 Watts
*Illustration may differ from actual product.
1. Temperature Control Dial
2. Red Pilot Light
3. Steam Trigger
4. Water Inlet Cover
5. Red Lint Brush
6. Bristle Garment Brush
7. Locking Tab
8. Swivel Handle
9. Water Measuring Beaker
10. Dual Voltage Selector
(not shown)
2