To Stop The Compressor - Ayce JLVWB6L Mode D'emploi

12.3 Adjusting the output air pressure
1. Turn the compressor on. When the maximum air pressure of 10 bar is reached as
indicated by the tank pressure gauge (2), the motor will stop.
2.Turn the pressure regulator (3) knob counterclockwise to decrease the output
pressure, turn it clockwise to increase the output pressure. When the output air
pressure gauge (4) shows the pressure you want, the pressure regulator (3) is set.
Tank pressure gauge (2)
12.4

To stop the compressor

1. Push the ON/OFF power switch (7) to its "OFF" position.
2. Press trigger on tool to relieve air pressure in hose. Disconnect hose from the
airoutlet.
3. Relieve the air tank pressure and remove moisture by opening the tank drain
valve(8). Turn the valve slowly counterclockwise until the pressure is relieved.
Then,retighten the drain valve (8).
4. Allow the air compressor to cool completely. Then store the unit in a clean, dry,
safe location out of reach of children.
JLVWB6L (1330985)
Pressure regulator (3)
Fig. 2
Output pressure gauge (4)
(after compressor)
EN
09
|