Installation Instructions - Ayce JLVWB6L Mode D'emploi

18. Have your power tool repaired by a qualified electrician
This compressor complies with the relevant safety regulations. Repairs may only
be carried out by a qualified electrician using original spare parts. Otherwise,there
is a risk of accidents for the user.
19. Noise
Wear hearing protection when using the compressor.
20. Do not touch the hot parts of the compressor
To avoid burns, do not touch the cables, the motor and all other components of
the compressor.
Keep the safety instructions for future reference.
7

INSTALLATION INSTRUCTIONS

Check the tool for transport damage. Report any damage immediately to the
transportation company that was used to deliver the compressor.
Install the compressor close to the point of use.
Avoid long air lines and supply lines (extension cables).
Always make sure that the intake air is dry, dust-free and non-explosive.
Do not install the compressor in a damp or wet room.
The compressor may only be used in suitable rooms (with good ventilation and an
ambient temperature from +5 °C to 40 °C). There must be no dust, acids,vapours,
explosive or inflammable gases in the room.
The compressor is designed for use in dry rooms. It is prohibited to use it in work
environments with splashing water.
8 SAFETY INSTRUCTIONS FOR WORKING WITH COMPRESSED AIR
Compressors and lines reach high temperatures during operation and touching
them may lead to burns.
Gases or vapours drawn in by the compressor should be kept free of constituents
that may cause fire or explosions inside the compressor.
When you disconnect the hose coupling, hold the coupling element of the hose in
your hand to prevent injury from the whipping hose.
9 OPERATION OF PRESSURE VESSELS ACCORDING TO PRESSURE VESSEL
REGULATIONS
The operator of a pressure vessel is required to keep the pressure vessel in good
working order, to operate it properly, to supervise it, to promptly carry out necessary
maintenance and repair work and to take safety measures as appropriate in the
circumstances.
The supervisory authorities may order appropriate supervisory measures on an
individual basis.
A pressure vessel may not be operated if it has any defects that present a danger to
the employees or third parties.
The pressure vessel must be regularly checked for damage, such as rust. If you
discover any damage, please contact the customer service centre.
JLVWB6L (1330985)
EN
06
|