Maintenance And Service; Maintenance And Cleaning - Bosch PLL 5 Notice Originale

OBJ_BUCH-311-005.book Page 30 Wednesday, July 14, 2010 11:45 AM
30 | English
– Fastening with a Screw: Place the wall holder 1 via
the opening on the back side onto a screw that
projects lightly out of the wall.
– Fastening with Adhesive Tape (see figure I): The
wall holder can also be fastened with commercially
available adhesive tape (not included in the delivery
scope) as shown in the figure.
For all four fastening methods, pay attention that the
wall holder 1 is fastened securely to the structural sur-
face. Faulty measurements can result when the wall
holder slips away.
Attach the measuring tool via the magnets 14 onto the
metal plate 3 of the wall holder 1.
Belt Clip
With the belt clip 5, the measuring tool, as an example,
can be hooked to a belt and is always at hand.

Maintenance and Service

Maintenance and Cleaning

Check the measuring tool each time before use. In
case of visible damage or loose components inside
the measuring tool, safe function can no longer be
ensured.
Keep the measuring tool clean and dry at all times to
ensure proper and safe working.
Wipe off debris using a moist and soft cloth. Do not use
any cleaning agents or solvents.
1 609 929 W57 | (14.7.10) Bosch Power Tools