Table des Matières
Publicité
•
Make sure that the adapter always is locked in the
appliance.
•
Fasten the battery cable in the attachments on the
harness.
Operation
•
Always wear working clothes and long trousers.
•
Backpack battery must be carried on the back while
usage.
•
Regulary check that the battery charger and the
battery are intact.
•
After switching the backpack battery on, there is a
startup time of about 4 seconds (software booting).
During that time, you can hear the fans inside the
backpack battery blowing and a green LED on the
battery is blinking. When the LED is lit green on the
battery, you can start to use the machine (only for
usage with Hedgetrimmer 136LiHD50 or Trimmer
136LiC: Please press the ON button on the machine
for at least 2 seconds to start working).
•
Battery switches off automatically when not used for
longer time (20 min approx). To restart, switch on
power switch (10).
•
Use the battery in surroundings where temperatures
are between -10 ° C and 40 ° C.
Battery display and adapter display
NOTE!
The adapter display will show the correct battery charge
status but at the beginning minor deviations are possible.
Both displays show the battery capacty (7, 12) and
eventual problems with the battery (8, 14). The battery
capacity is displayed by pressing the battery indicator
button (6,11). The Warning symbol is lit if an error has
occured. See fault codes.
LED lights
All LEDs are lit
LED 1, LED 2, LED 3, LED
4 are lit
LED 1, LED 2, LED 3 are lit.
LED 1, LED 2 are lit.
LED 1 is lit.
On adapter display, capacity indication is shown in 1%
steps.
Charging (fig. A)
The battery must be charged before using it the first time.
The battery is maximum 30% charged when delivered.
•
Always switch on the battery on the power switch (10)
(green LED (13) is lit).
6 – English
BATTERY HANDLING
Battery status
Fully charged (80%-100%).
The battery is 60%-80%
charged
The battery is 40%-60%
charged.
The battery is 20%-40%
charged.
The battery is 0%-20%
charged.
•
Put the adapter in the battery charger. Make sure the
adapter is fitted correctly in the battery charger. (2, 5)
•
The green charging light on the charger is lit when the
battery is connected to the battery charger. (3)
•
The capacity indication (7) on the adapter and the
power LED on the battery (13) are flashing during
charging.
•
Remove the adapter from the charger after charging.
NOTE!
During charging, monitoring the charging process and
never leave the battery in the charger when charging is
complete.
NOTE!
Make sure that the battery to be charged must be placed
on a non-flammable, heat resistant and non-conductive
surface while charging.
Transport and storage
•
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements.
•
For commercial transports e.g. by third parties,
forwarding agents, special requirement on packing
and labeling must be observed.
•
For preparation of the item being shipped, consulting
an expert for hazardous material is required. Please
also observe possibly more detailed national
regulations.
•
Tape or mask off open contacts and pack up the
batteriy in such a manner that it cannot move around
in the packing.
•
Store the equipment in a lockable area so that it is out
of reach of children and unauthorized persons.
•
Store the battery, the adapter and the battery charger
in a dry, moisture-free and frost-free space.
•
Store the battery where the temperature is between 5
° C and 25 ° C and never in direct sunlight.
•
Be sure to store the battery and the adapter separated
from the battery charger.
•
Do not store the battery in places where static
electricity can occur. Never store the battery in a metal
box.
•
Before longer storage please charge the battery.
The energy density of the back pack battery is higher than
100 W/h. Therefore it is not allowed to send it by post.
Please contact your local dealer.
Publicité
Table des Matières
