Standard Models; Alarm Mode; Setup Menu - DeFelsko PosiTector DPM Guide Rapide

Alarm
The PosiTector DPM can automatically alert the user when
current climatic conditions exceed pre-set values. When selected,
the Alarm icon

Standard models

temperature is less than 3°C (5°F) above the dew point
temperature. Enable by selecting the tick box.
Advanced models
conditions for each reading in a dataset.
Reset
Reset (soft reset) restores factory settings and returns the
instrument to a known condition. The following occurs:
- All batches and stored datasets are erased.
- Menu settings are returned to the following:
Memory = OFF
Auto Log = OFF
Perform a more thorough Hard Reset by powering down the
instrument, waiting several seconds, then simultaneously holding
both the center
appears. This returns the instrument to a known, "out-of-the-box"
condition. It performs the same function as a menu Reset with the
addition of:
- Bluetooth Pairing info is cleared.
- Alarm settings are set to defaults.
- Menu settings are returned to the following:
Units = Celsius
Flip Display = Normal
Auto Sync = OFF
Alarms = OFF
Alarm Sound = OFF
Wet Bulb = OFF
White on Black = OFF
NOTE:
Date, Time and WiFi are not affected by either Reset.

Alarm Mode

Alarm Mode
is displayed at the the top of the screen.
will alert the user when the surface
allow the user to set up custom alarm

Setup Menu

Setup Menu
and (+) buttons until the Reset symbol
Language = English
Battery Type = Alkaline
Backlight = Normal
Auto Log Interval = 5 min
Bluetooth Streaming = OFF
USB Drive= ON
Bluetooth = OFF
Trend Chart = None
3