Monitor Pack; Locating Faulty Components; Service And Repair - RIDGID SeeSnake Compact Manuel De L'opérateur

SeeSnake
NOTE! Never fill the drum with water with the reel
on its back (open side of drum facing up)!
Water entering the hub could damage the slip
rings inside (Figure 29).
Figure 29 – Never Fill the Drum with the Reel On Its Back

Monitor Pack

Wipe the Monitor Pack with a damp cloth. Clean the
monitor screen with a small amount of window cleaner
sprayed on a soft, lint-free cloth. Monitor wipes, available
at most computer and office-supply stores, not only
clean the screen, but also help prevent dust build-up.
Always avoid dropping or shocking the Monitor Pack. The
abrasion resistant acrylic shield can be cleaned with
household glass cleaner and a soft damp cloth.
NOTE! Although the acrylic window resists scratching,
care should be taken to brush off excess abra-
sive particles prior to cleaning.

Locating Faulty Components

For troubleshooting suggestions, please refer to Chart 1
at the end of the manual. If necessary, contact RIDGE
Tool Technical Service at 800-519-3456.
14
® Compact and Color Compact

Service and Repair

CAUTION
Tool should be taken to a RIDGID Independent Authorized
Service Center or returned to the factory. All repairs
made by Ridge service facilities are warranted against de-
fects in material and workmanship.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find
your local RIDGIDl contact point.
• Contact RIDGID Technical Services Department at
rtctechservices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.