Shutdown Instructions - Dyna-Glo DGB494SPB Mode D'emploi

OPERATION INSTRUCTIONS
LIGHTING THE GRILL WITH A MATCH
1. Open the lid.
2. Insert a match in the end of the match holder that is installed on the right leg assembly.
3. Light the match.
4. Immediately place the lit match through the spaces in the grill gates near the ports of the burner
between the heat tents as shown. Make sure the lit match is close to the burner ports.
5. Press in the control knob that operates the burner and rotate
position and burner should light immediately.
6. Repeat 2~5 steps to lighting the remaining burners.
7. Adjust burners to desired cooking settings.
Make sure all burners controls are off except for the burner being lit and the
burners that have been lit.
If ignition does not occur in 5 seconds, turn the control knob(s) to "O" OFF position, wait 5
minutes, and repeat the lighting procedure.
Main Burner Match Lighting

SHUTDOWN INSTRUCTIONS

1. Turn control knobs
2. Close valve at tank fully by turning
3. Close lid.
Turn off LP supply at cylinder when appliance is not in use.
CAUTION
WARNING
O
clockwise to the OFF position.
clockwise.
counter-clockwise to
Side Burner Match Lighting
21
High