Assembly Instructions - Dyna-Glo DGC310CNP Manuel D'utilisation

ASSEMBLY INSTRUCTIONS

1. Install left rear leg cap (T) onto left
rear cart leg (J). Then install left front
leg cap (U) onto left front cart leg(L) as
illustrated. Use four M6x12 bolts (AA) to
fasten the Cart Left Upper Brace Assembly (K)
and Cart Left Lower Brace Assembly (M)
onto Left Front Leg Assembly (L) and Left Rear
Leg Assembly (J).
Hardware Used
AA
M6x12 Bolt
2. Place the tank support bracket (W)
between the Right Front Leg Assembly (O) and
Right Rear Leg Assembly (N), use two
wheel axles (BB) to go through the both two
wheels (V), right front leg assembly (O)
and right rear leg assembly (N), then insert
the two cotter pins (CC) to secure. Use
four M6x12 bolts (AA) to fasten the Cart
Right Upper Brace Assembly (S) onto the right
front leg assembly (O) and right rear leg
assembly (N).
Note: Follow the arrow direction on the Cart
Right Upper Brace Assembly (S) when install.
Hardware Used
AA
M6x12 Bolt
BB
Wheel Axle
Cotter Pin
CC
Wheel axle
x 4
x 4
x 2
x 2
Wheel axle
Cotter pin
7
1
J
AA
K
M
T
Wheel axle
2
O
BB
Wheel axle
Cotter pin
L
U
Cotter pin
AA
N
S
CC V
W
Cotter pin