Shutdown Instructions - Dyna-Glo DGH483CRP Mode D'emploi

OPERATION INSTRUCTIONS
LIGHTING THE GRILL WITH A MATCH
1. Open the lid.
2. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
3. Light the match.
4. Immediately place the lit match through the spaces in the grill gates near the ports of the burner
between the heat tents as shown. Make sure the lit match is close to the burner ports.
5. Press in the control knob that operates the burner and rotate
position for the main burners and
6. Repeat 2~5 steps to lighting the remaining burners.
7. Adjust burners to desired cooking settings.
Make sure all burners controls are off except for the burner being lit and the
burners that have been lit.
If ignition does not occur in 5 seconds, turn the burner control(s) OFF
and repeat the lighting procedure.

SHUTDOWN INSTRUCTIONS

1. Turn control knobs
2. Close valve at tank fully by turning
3. Close lid.
Turn off LP supply at cylinder when appliance is not in use.
for the sear burner which should light immediately.
CAUTION
WARNING
Main Burner Match Lighting
O
clockwise to the OFF position.
clockwise.
counter-clockwise to the
23
high
O
. Wait 5 minutes,