Electric Connection - GOK LWG 2000 Notice De Montage Et De Service

Mounting the display unit
Remove the display unit from
the packaging.
Check for completeness,
damage and labelling.
Unscrew 4 screws on the front
of the display unit.
Remove the front of the
display unit.
Drill 2 mounting holes Ø 5
mm.
Mount the display unit with the
2 enclosed S5 anchors and
wood screws
3 x 35 DIN 96.

ELECTRIC CONNECTION

The housing of the display unit is suitable for wall mounting and is connected to
the 230 V mains supply. Under normal circumstances, the display unit must be operated with
the housing cover closed. It is installed and started up by a qualified technician while the unit
is open.
Safety precautions for electrical components
The functions and operating safety of the device are guaranteed only under the climatic
conditions that are specified in TECHNICAL DATA. If the device is transported from a cold to
a warm environment, condensation may cause the device to malfunction or may even destroy
the device. Because of this, you must ensure that the device has acclimatised to the ambient
temperature before using it.
If you have any doubts that the device can be operated safely, do not operate it. Your safety
may be adversely affected by the device, if for example:
• it is obviously damaged
• it no longer works as specified
• it has been stored in unsuitable conditions for some time,
if in doubt, send the device to the manufacturer for repair or maintenance
part no. 15 073 57 c
Danger to life due to electric shock!
Electric shock from touching live parts.
Before opening the housing, ensure that the equipment is free of
all voltage.
Only place under tension after ending all work.
Leak alarm type LWG 2000
7 / 16