SI Analytics TITRONIC 500 Mode D'emploi page 91

The Sample Quantity (W) item is used to select whether one is wishing to use a sample weight or a sample
volume for titration or solution preparation.
You have the following options (Fig. 62):
• Manual sample weight: The sample weight is enquired by a prompt at the start of the method and
manually input.
• Automatic sample weight: The sample weight is automatically transferred by a connected balance.
• Fixed sample weight: A fixed sample weight is input in g. This weight will then automatically be used for
each start of the method without any sample weight being enquired by a prompt.
• Manual sample volume: The sample volume in ml is prompted at the start of the method and manually
input.
• Fixed sample volume: A fixed sample volume is input in ml. this volume will then automatically be used
for each test of the method without any sample volume enquired by a prompt.
Note: Manual and firm sample volumes are orally available of for manual titration.
4.5.2.4 Formula unit
The formula unit can be selected in the Unit submenu.
Fig. 63
Once the selection made (e.g. %), the unit will also be displayed as piece of information on the display.
Fig. 64
4.5.2.5 Decimal digits
To conclude, it is possible to determine the number of decimal digits from 2-6. The standard setting is 2.
Chapter 4 Method Parameters
91