Publicité
Les langues disponibles
Les langues disponibles
Product Information
– Always keep these instructions together with the product even when given to other persons.
– Check expiration date: See imprint on foil pack manifold (month/year). Do not use expired product.
– Foil pack temperature during usage: 5 °C to 40 °C / 41 °F to 104 °F.
– Base material temperature at time of installation: -5 °C to 40 °C / 23 °F to 104 °F.
– Conditions for transport and storage: Keep in a cool, dry and dark place between 5 °C and 25 °C
/ 41 °F and 77 °F.
– For any application not covered by this document / beyond values specified, please contact Hilti.
– Partly used foil packs must be used up within 4 weeks. Leave the mixer attached on the foil pack
manifold and store under the recommended storage conditions. If reused, attach a new mixer and
discard the initial quantity of anchor adhesive. A new mixer must be used for each new foil pack.
NOTICE
Improper handling may cause mortar splashes.
– We recommend to wear safety glasses, gloves and protective clothes during installation.
– Never start dispensing without a mixer properly screwed on.
– Attach a new mixer prior to dispensing a new foil pack (ensure snug fit).
– Use only the type of mixer supplied with the adhesive. Do not modify the mixer in any way.
– Never use damaged foil packs and/or damaged or unclean foil pack holders (cassettes).
Poor load values / potential failure of fastening points due to inadequate borehole cleaning.
– The boreholes must be free of debris, dust, water, ice, oil, grease and other contaminants prior
to adhesive injection.
– For blowing out the borehole - blow out with oil free air untilreturn air stream is free of noticeable
dust.
– For brushing the borehole – only use specified wire brush. The brush must resist insertion into the
borehole – if not the brush is too small and must be replaced.
Ensure that boreholes are filled from the back of the borehole without forming air voids.
– If necessary use the accessories / extensions to reach the back of the borehole.
Printed: 01.06.2016 | Doc-Nr: PUB / 5276256 / 000 / 02
Hilti HIT-CT 1
en
de
fr
it
nl
es
pt
da
no
sv
fi
pl
sk
cs
sl
li
lv
et
ru
zh
ko
jp
25
Publicité
