Hilti HIT-CT 1 Mode D'emploi page 24

Hilti HIT-CT 1
Adhesive anchoring system for anchor fastenings in concrete
Prior to use of product, follow the instructions for use and the safety precautions.
▶
Classification and labelling according to Regulation (EC) No. 1272/2008 [CLP]
Hazard pictograms:
Signal words:
Hazard statements:
Precautionary statements:
P262
P305 / P351 / P338
P302 / P352
Supplemental information:
EUH208
EUH210
Disposal considerations
Empty packs:
Leave the mixer attached and dispose of via the local Green Dot collection system
▶
Full or partially emptied packs:
On the basis of the necessary technical regulations and after consultation with the disposal agent and
▶
the relevant authorities, can be deposited with domestic waste or incinerated with domestic waste.
- or -
Dispose of as non-hazardous waste according to:
▶
– EAK waste material code: 20 01 28 paint, inks, adhesives and resins.
– or EAK waste material code: 08 04 10 waste adhesives and sealants.
Content: 330 ml / 11.1 fl. oz 500 ml / 16.9 fl. oz
Hilti accepts no liability for damage or failure caused by:
– Storage and transport not in accordance with the specified conditions.
– Failure to observe the instructions for use and setting data, incorrect use
– Inadequate design of the anchor points, inadequate load bearing capacity of the base material
– O ther influences of which Hilti is not aware or on which Hilti has no influence, e.g. use with products
from a third party.
24
Printed: 01.06.2016 | Doc-Nr: PUB / 5276256 / 000 / 02
none
none
none
Do not get in eyes, on skin, or on clothing.
IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing.
IF ON SKIN: Wash with plenty of soap and water.
Contains dibenzoyl peroxide. May produce an allergic reaction.
Safety data sheet available on request.
Weight:
600 g/21.1 oz 910 g/32.1 oz