Weston Realtree Edge 73-0701-RE Instructions page 5

PLUNGER ASSEMBLY
1. Slide the Plunger Seal onto the
Plunger (Figure 1).
2. Assemble the Pressure Release
Valve Kit onto the Plunger. From the
top of the Plunger, place the Washer
onto the Valve Hole, then insert the
Screw through the Washer and into the
Valve Hole. From the underside of the
Plunger, place the Spring onto the end
of the Screw, then place the Valve Cap
onto the end of the Screw and twist to
secure.
3. Screw the Plunger Bolt onto the
Plunger Shaft (Figure 2).
4. Place the assembled Plunger onto
the end of the Plunger Shaft (Figure 3).
STUFFER ASSEMBLY
5. Attach the Handle by sliding it onto
either the Fast or the Slow Gear (Figure 4).
6. Crank the Handle to bring the
Plunger to the top of the Stuffer.
Continued Next Page
ASSEMBLY
Figure 1
Plunger
Seal
Plunger
Valve Hole
Plunger
Shaft
Figure 3
Plunger
-5-
Figure 2
Pressure
Release
Valve Kit
Screw
Washer
Spring
Valve Cap
Fast Gear
Shaft
Figure 4
Slow Gear
Shaft
Handle
Plunger
Shaft
Plunger
Bolt