Disposal; Troubleshooting - Zipper ZI-GHAS2800 Manuel D'utilisation

 If you wait for the chopper blade set, be aware about the fact that the knife can still be
moved by a manual start mechanism, although the engine will not start due to the locking
of the guard.
15.1

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for infor-
mation regarding the available disposal options. When you buy at your local dealer for
a replacement unit, the latter is obliged to exchange your old.
16

TROUBLESHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself!
Trouble
Engine will not start
The material to be
chopped is not feeding
The cutting of the ma-
terial is not good
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the prob-
lem.
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-GHAS2800
Possible cause
 The overload protection has
responded
 power failure
 Safety switch not closed to
the collecting container capa-
ble
 The chopping blade rotates
backwards.
 The media is jammed in the
feed hopper.
 The distance of the baffle to
the cutting blades is wrong
 Removed jammed parts. Let the
motor cool down for about 2min and
push the reset button of the motor
protection.
 Check the mains cord, the plug and
the fuse in your home port and the
residual current circuit breaker
 Make sure that the On-collecting
vessel, and be locked in the safe po-
sition
 Change the direction of rotation.
 Push Reverse switch and turn the
shredder on. Put out the material
from the shredder.
 Adjust the right distance with the
adjusting knob
N O T I C E
TROUBLESHOOTING
Solution
Seite29