Panel; On/Off; Rotation Direction Switch; Motor Protection - Zipper ZI-GHAS2800 Manuel D'utilisation

14.2

Panel

14.2.1 On/Off

 Push green button (1 ON - switch)"1" — the shredder starts
 Push red button (2 OFF - switch)"0" — the shredder stops

14.2.2 Rotation direction switch

 4 Forward button" ". The material is automatically pulled in and shredded by knife.
 5 Reverse button"
material will be released.
If the material is jammed, first press the red button to stop the machine. Press the reverse
button and then the green button to start the machine again. Remove the jammed material.
Press the red button to stop the machine again and press the forward button. Then you can
continue to work.

14.2.1 Motor protection

This machine is equipped with an overload protection system. To protect the motor from being
damaged the safety switch will automatically switch off the power.
When the motor is overloaded wait at least 2min to cool down the motor and:
1. Reset button (Motor protection)
14.3

Operation instructions

1. Press the on switch, the unit starts up.
2. The reverse button can be used when the machine is in good working condition. Then press
the forward button in order to run counterclockwise. Press reverse button to run it clockwise.
3. When removing the collection container during operation of the device the unit will stop au-
tomatically.
4. After mounting the collection box. The unit will start after pressing the on switch.
5. If power is suddenly interrupted during operation, the machine stops. The unit starts again
when you press the on switch.
6. Press only to stop the off the device. After that, the pressing of the manual forward and re-
verse switch is no longer possible.
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-GHAS2800
Use the rotation direction switch only when machine is off!
" The Knife works in the opposite direction of rotation, jammed
A T T E N T I O N
2. Green button "1" to restart
OPERATION
Seite26