Adjust Buffle; Maintenance - Zipper ZI-GHAS2800 Manuel D'utilisation

14.7

Adjust buffle

The best distance between baffle ②
and the cutting blades ① is 0 from
0,50 mm. This distance should be
adhered to in order to achieve suc-
cessful work.
There is an adjustment on the right
side of the plastic case. To adjust
the distance, turn the knob
clockwise, so that the bolt is to-
wards blade rotates. With a half
circle, the panel moved 0.50 mm
toward cutter. Perform after adjust-
ing cutting tests to check whether
the best result is achieved. Make
sure that the blade does not strike
against the panel to prevent damage to the appliance.
15

MAINTENANCE

Vor Wartungsarbeiten Maschine ausschalten und den
Netzstecker ziehen!
Sachschäden und schwere Verletzungen durch unbe-
absichtigtes Einschalten der Maschine werden so ver-
mieden!
The machine is low maintenance and contains little parts that must undergo a maintenance
operator. Faults or defects that may affect the safety of the machine, must be rectified
immediately. Repairing work may only be performed by qualified personnel!
 Make sure that your machine and clean it regularly to get a long-lasting effectiveness and
efficiency.
 Keep the air vents clean and free of dust.
 Only use a warm damp cloth and a soft brush to clean your machine.
 Clean the machine. Never under water or even with high pressure.
 Do not use detergents or solvents as these could cause irreparable damage to your ma-
chine. Chemicals can damage the plastic parts.
 Check from time to time, the tightness of the mounting bolts on the undercarriage.
 To protect the chopper in storage for a long time against corrosion, handle the chopping
blade with something biodegradable oil.
 When the machine for maintenance, inspection or storage or for the replacement of acces-
sories is off, turn the engine off, unplug the power cord out and make sure that all moving
parts have come to a standstill. Let the machine cool down before you make any inspection,
adjustment, etc.
 The chopper can be packed into the container for storage and transport.
Follow the steps listed below:
 Store the machine in a dry place. Let the unit run for longer retention periods short dry.
Allow the engine to cool before you store it.
Z.I.P.P.E.R Maschinen GmbH  www.Zipper-maschinen.at
ZI-GHAS2800
③
A C H T U N G
MAINTENANCE
Seite28