Turning On And Off; Cleaning And Servicing; Cleaning; Servicing - Deltafox DP-EAG 7525 Traduction De La Notice D'utilisation Originale

GB
Wear protective gloves when
changing the tool so as to avoid
injuries from cuts.
The clamping nut must not be
screwed too tightly so as to avoid
breaking the disc and nut.

Turning on and off

Make sure that the power supply
voltage matches the voltage rat-
ing indicated on the device's type
plate.
Connect the machine to the power
supply.
1. To start, push the switch lock (4a)
forwards towards the tool and press
the on/off switch (4) into the tool's grip
surface.
2. To turn off, release the on-off switch.
The tool will switch off.
After switching on the device, wait until
the device has reached its max. speed.
Only then should you start with the work.
The tool still runs even after the
device has been switched off.
Risk of injury.
Trial run:
Always carry out a trial run without a load
before carrying out your first procedure
as well as after every tool change. Switch
the device off immediately if the tool is not
rotating smoothly, if considerable vibration
occurs, or if you hear abnormal noises.
36

Cleaning and servicing

Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this in-
struction guide performed by a
professional. Only use original
parts. Allow the device to cool
off before any maintenance or
cleaning is undertaken. There is
a risk of burning!
Always check the device before using it
for obvious deficiencies such as loose,
worn or damaged parts, correct the posi-
tioning of screws or other parts. Examine
the grinding disc in particular. Exchange
the damaged parts.

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after
every use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.

Servicing

Prior to every use, check the appliance for
obvious defects such as loose, worn or
damaged parts.