Operation - Deltafox DP-EAG 7525 Traduction De La Notice D'utilisation Originale

scope of delivery). You can now re-
lease the spindle stop button (1).
4. Place the desired wire brush onto the
mounting spindle.
5. Press the spindle stop button (1) and
rotate the wire brush on the mounting
spindle (14). Tighten the wire brush
using a combination wrench. You can
now release the spindle stop button
(1).

Operation

Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
- Only use grinding discs and
accessories recommended by
the manufacturer. Using other
attachment tools and other ac-
cessories can represent a risk
of injury for you.
- Only use accessory parts which
bear information about the
manufacturer, type of connec-
tion, dimension and permitted
number of revolutions.
- Only use accessory parts where
the printed rotational speed is at
least as high as what has been
specified on the name plate of
the device.
- Do not use any broken,
cracked, or otherwise damaged
grinding discs.
- Never operate the device with-
out protective equipment.
- Support the plates or work-
pieces in order to reduce
the risk of kickback from a
jammed cutting disc. Large
workpieces may bend under
their own weight. The workpiece
must be supported on both
sides of the disc, not only near
the cutting disc, but also at the
edge.
Keep your hands away from the
disc when the device is in op-
eration. Risk of injury.
Information on replacement:
• Never operate the device with-
out protective equipment.
• Ensure that the rotation speed
stated on the tool is the same
or higher than the nominal idle
speed of the device.
• Ensure that the tool dimensions
match those of the device.
• Only use flawless discs (ringing
test: when you strike the grind-
ing disc with a plastic hammer,
it results in a clear sound).
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs with a hole that is too
large fit the device.
• Do not use any saw blades.
• To clamp the grinding tools
only use the clamping flange
provided. The pads between
the clamping flange and the
grinding tools must be made of
elastic materials e.g., rubber,
soft cardboard etc.
• Reassemble the device com-
pletely after replacing the tool.
Switch the device off and remove
the mains plug. Allow the device to
cool down.
GB
35